indutrial roof repairs example {town} indutrial roof repairs example {town} indutrial roof repairs example {town} indutrial roof repairs example {town} indutrial roof repairs example {town} indutrial roof repairs example {town}
Using our own high access equipment
reduces the need of scaffolding in 98% of our repairs
Practical Roof Solutions Ltd is a member of;
National Federation of Roofing Contractors
If you would like a free no obligation quotation, please complete the form below. Remember to add a photo that shows the problem.
Your Name
Contact Number
Email Address
Site Postcode
Description of Job
Photo 1
Photo 2
Photo 3
Security key
Re-Type Security Key
Chimneys Walsall, West Midlands
Chimneys - Chimney repair Walsall

Leaning Chimneys repaired by 

Walsall Industrial Roofing.

Your chimney is exposed to the full force of the weather and, to ensure the chimney can withstand such a variety of conditions, it should be checked regularly for any potential problems.

By keeping an eye on your chimney’s condition or change of condition, repairs can be carried out as soon as they’re necessary, preventing bigger problems further down the line.

A combination of erosion, acid attack and salt crystallisation are liable to cause a chimney to lean. The BRE Good Repair Guide says any chimney that leans more than 1mm in 100mm is unsafe. This is perhaps a little too cautious and where historic buildings are concerned, one may wish to apply the middle third rule to the shaft wall around the flue. Thus where the shaft wall is half a brick thick, a lean of 35mm could be tolerated, but if in any doubt, consult a structural engineer.
Where repairs are impossible, the remedy of last resort is to rebuild the stack from some convenient point - say the top section only or completely from below roof level - using as much salvaged material as possible. To comply with The Building Regulations any rebuilt section will have to have an internal diameter of 200mm (although 185mm is acceptable for a relined flue), so some ingenuity may be required to incorporate a flue liner within the original stack dimensions.

If it is decided that the existing lean on a stack can be tolerated the factors inducing the lean should be stabilised. The flue should be lined and broken or decayed bricks should be cut out and replaced. In slender stacks it is a wise precaution not to take out too many bricks at a time (sometimes no more than one at a time) and the new mortar must be allowed sufficient time to achieve strength before proceeding with the next area of cutting out. Cracks should be repointed and all 'defective' mortar raked out and repointed.


'Defective' mortar may be taken to include that which is loose, crumbling or cracked. As a general principle (and this applies to all repointing, not just on chimneys) if a lime mortar is difficult to remove, repointing is not necessary. Any hard cement mortar will be more difficult to remove. Take care not to damage the edges of the brick or stone. Rake out to a depth of 25mm or twice the width of the joint whichever is the greater; do not rake out deeper than 35mm. The strength and lime content of the mortar will depend on the hardness of the brick or stone, in accordance with usual good practice for repointing. If it is necessary to add some cement to the mix, use sulphate-resisting cement. Similar mixes will be used for rebuilding stacks.
Once a leaning stack has been stabilised, some periodic checking (for example during quinquennial inspections) is advisable.